Jump to content

Recommended Posts


yeah I know, extremely grateful :)

 

Its in the post :thumbs:

 

A cheap Chinese bipod is still pretty good, they attach to the stud with 2 pins either side and when you tighten the thumb screw they close up into the stud and then tighten against your stock. your sling then attaches to the bipod with QD swivels.

 

iv got a spare pair of uncle mikes QD swivels so iv popped them into the envelope aswell for you.

 

sometimes the hole that the uncle mike swivel goes through on the bipod is a bit too small but its only a 2 minute job to open them up slightly with a drill bit.

 

when you drill the rear stud screw stick a bit of electrical tape over where your going to drill and start off with a small pilot hole, take your time and use sharp drill bits

 

:thumbs:

Link to post
  • 2 months later...

As villaman said pal. I had the same on my Aas410 and it was good. I have an Edgar Brothers 9-12 on my 100 and it's nice and quiet and I've found that the tilt lock stays tighter than a lot of others I've tried but it £65 instead of £15 but still better in my opinion than the Harris.

Link to post

Like i said Harris ones are over priced and over rated imo ,the ones from JS Ramsbottom are great and even better for £15

 

the ramsbottoms are a good price and bloody good for the money. The Harris seems shoddy imo for the money compared to the Edgar bros which is finished far better and far less twangy for the same money.
Link to post

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...