Sarci sparki 16 Posted March 7, 2015 Report Share Posted March 7, 2015 Right basically is this possible? Ordered two rotary cutters and neither have arrived for what feels months.. and as one of my tbg snapped on a pretty old double setup I snipped the other one off and discovered 11mm lead and single 20-15 is spot on with the easy draw, if feeling a little less snappy than I would like, so desperate to make a quick single 25-20 setup to go do some woody and magpie shaped targets tonight lol Quote Link to post Share on other sites
the monkey 337 Posted March 7, 2015 Report Share Posted March 7, 2015 Did mine with a pair of dressmakers scissors Quote Link to post Share on other sites
youcanthide...BANG 1,051 Posted March 7, 2015 Report Share Posted March 7, 2015 Yep I've never used a rotary cutter. Use a snap off craft blade or Stanley knife. Mark the width of your bands with a pen. Put sellotape over that mark. With a metal ruler or other straight edge run down your mark. Better than any rotary cutter I think 1 Quote Link to post Share on other sites
the big chief 3,099 Posted March 7, 2015 Report Share Posted March 7, 2015 rottery cutter for me ebay £5 Quote Link to post Share on other sites
Sarci sparki 16 Posted March 7, 2015 Author Report Share Posted March 7, 2015 Yeah ive ordered two ages ago gaffer and none has arrived yet, ych why cellotape? Sounds spot on if I can find some tape now lol, cheers fellas appreciated Quote Link to post Share on other sites
youcanthide...BANG 1,051 Posted March 7, 2015 Report Share Posted March 7, 2015 Keep the bands from stretching for a clean cut. Otherwise the blade just catches all way along 2 Quote Link to post Share on other sites
Sarci sparki 16 Posted March 7, 2015 Author Report Share Posted March 7, 2015 Thanks mate, will update if all goes to plan Quote Link to post Share on other sites
Sarci sparki 16 Posted March 7, 2015 Author Report Share Posted March 7, 2015 Nope didnt go to plan lol.jagged edges along the edge, brand new blade in it aswell, gutted lol Quote Link to post Share on other sites
youcanthide...BANG 1,051 Posted March 7, 2015 Report Share Posted March 7, 2015 Hmmmm, try keep the blade as low as possible, and make sure that you put enough pressure on the blade. I've never had a problem and neithers anybody else who I've shown how to do it Quote Link to post Share on other sites
flynndog 543 Posted March 7, 2015 Report Share Posted March 7, 2015 Need to put some pressure on with straight edge too and like ych says keep blade nice and low 1 Quote Link to post Share on other sites
Sarci sparki 16 Posted March 7, 2015 Author Report Share Posted March 7, 2015 Nice and low is where I was going wrong, the last inch has the tinyest nick, not even half a mm but itll do for a night, does everyone use pouch rigs to tie onto the pouches? Thanks for the info fellas Quote Link to post Share on other sites
paddy65 6 Posted March 7, 2015 Report Share Posted March 7, 2015 rotory cutter on a glass board with a steel rule,got cutter from the range £2.99 spare blades a quid ATB paddy Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.