For Sale Cudeman Knife Blades

[leaky5 2]

Cudeman blade blanks.

 

I bought these to use up some timber I had, but have been failing to get the holes drilled straight. So am giving up with knife work for now.

 

They are all new. The top 2 are the same, overall length 195 blade 85 and the bottom one is overall 205 blade 90.

 

They are made from 440c stainless steel and would be good for someone wanting to have a go a handle (scale) fitting.

 

They will take 8mm lanyard tubes and ¼ Corby bolts.

 

As you can see from the pictures I have attempted to enlarge some of the holes. Not easy in 440c and one of the reasons I am not carrying on with them as I wanted to put larger pins through them. This should not be a problem as the holes will be covered completely by the handles.

 

£15 each posted of £40 for all three.

 

Over 18’s only.

 

 

 

 

 

[jonah. 775]

Cheap enough....

[paulus 26]

clamp the scales to the back of the handle then drill straight through from the front

[riohog 5,645]

use an oxy torch :laugh:

[paulus 26]

just seen that, why not use smaller pins

[leaky5 2]

Cheers guys. I have done scales by hand before, its just this wood is to soft and I can't get a stright hole through it. I was going to invest in a pillar drill but I can't really justify that at the moment.

 

I am going to stick with my sling and leather making for now. I know my limitations.

[leaky5 2]

Bottom one in first picture sold.

Edited August 22, 2014 by leaky5

[leaky5 2]

All now sold.