Recently Browsing 0 members
No registered users viewing this page.
Well I got 2 unused table clamps and a need for stability.
Cant afford the new style tripods <on furlough pay>,so I thought make your own. So drill n tap m10x1.5 in the base of said bracket .
Cut 2 pieces 7.5x3.5cm steel plate and fix to clamp .Drill hole and fit split pin to stop wind out in turnscrew. Then cut leather patches to fit and bond with contact adhesive, allowing 24 hours to cure and Bob's your job.
Stable, free and hands free atb
While you were playing with your new rifles I went and got me a 3" hatsan ford escort 12g and to be honest I am quite impressed!
I put 28, 29, 32 and 36 gram loads through it and home loads some of which were subsonic and it cycled the lot! And with no O ring present!
I eventually did put an O ring on it but it was to thick and just would not allow the hammer to strike the firing pin although the action was locked. It's quite a precise fit. I later fitted a smaller section ring and now it fires. The reason for the ring despite perfect function without one is that the barreled action is quite loose without it but with it it all snugs up nice.
The one stock adjuster made it a perfect fit for me too. As autos go it is a pleasant cyclic sensation too, not effecting aiming much at all. It's no lightweight but not ridiculous either.
No pictures as it's just a cheap auto and I have been busy building an arc to survive the floods!!
Now, just got to wait untill September and hope the new world order movement don't get a knee jerk law passed banning duck and goose shooting one day before the season!
Oh yes, no oil in the action at all !
Upgraded me phone and so called smart switch didnt it trashed my pheasant call mp3.Any kind peeps able to send me the distressed Pheasant call i would be most grateful .May the fruit of your loins be bountiful and you sire many a fine son ,thanks in advance kind gentilfolk