tomospants 3 Posted October 27, 2011 Report Share Posted October 27, 2011 hello you guys just a quick question is it easy to change a mainspring on a tx200 and do you need any special tools many thanks Paul. Quote Link to post
oscarsdad 4 Posted October 27, 2011 Report Share Posted October 27, 2011 Dead easy and no you don't need any special tools. From memory just an Allen key to remove the stock and then a spanner and a screwdriver Anthony Quote Link to post
Phantom 631 Posted October 27, 2011 Report Share Posted October 27, 2011 Why are you wanting to replace the spring? Is it buggered? Just be aware that the outgoing spring will be under tension and can be dangerous I've never seen a spring gun that hasn't had it's spring under tension even when not cocked. Its even harder to put a new one in than it is taking it out. Tony Quote Link to post
davyt63 1,845 Posted October 27, 2011 Report Share Posted October 27, 2011 hi buddy its pretty much simple,just follow these instructions!! http://www.freewebs.com/stripdowns/tx200hcstrip.htm hope this helps regards Davy 2 Quote Link to post
andyfr1968 772 Posted October 27, 2011 Report Share Posted October 27, 2011 Unless someone's fitted something daft to it, the spring will be under very little pre-load in a TX, they're good like that!! As above, they're a very easy gun to work on if you've got a reasonable bit of mechanical knowledge. Quote Link to post
tomospants 3 Posted October 28, 2011 Author Report Share Posted October 28, 2011 thanks guys i will give it a go. Quote Link to post
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.