chartpolski 25,886 Posted December 8, 2023 Report Share Posted December 8, 2023 7 minutes ago, mC HULL said: plastic speed fits easy and quick aswell chart question is what is a man of your calibre doing going threw water pipes lol To be honest, I had a water leak and had to replace a couple of floor boards in the spare bedroom. I finished the job and as I was leaving I stood on a squeaky board that had been annoying me for years, so, tools in hand, I drove a screw through it and straight through a pipe that was immediately below the floor board ! Those lazy b*****ds at Barratts had just notched the top of the joist to run the pipes instead of running them through the middle of the joist. Just imagine if I had done such a shoddy job on a 747 ???? Cheers. 2 Quote Link to post Share on other sites
mC HULL 14,587 Posted December 8, 2023 Report Share Posted December 8, 2023 7 minutes ago, chartpolski said: To be honest, I had a water leak and had to replace a couple of floor boards in the spare bedroom. I finished the job and as I was leaving I stood on a squeaky board that had been annoying me for years, so, tools in hand, I drove a screw through it and straight through a pipe that was immediately below the floor board ! Those lazy b*****ds at Barratts had just notched the top of the joist to run the pipes instead of running them through the middle of the joist. Just imagine if I had done such a shoddy job on a 747 ???? Cheers. been there mate most are notched in the middle central heating pipes aswell last one i did i had up to run wire for a shower but i put the floorboard the wrong way round but the pipe bent off half way so one end had nail at sides the other in the middle so when i tapped it down the nail went threw lol Quote Link to post Share on other sites
chartpolski 25,886 Posted December 8, 2023 Report Share Posted December 8, 2023 1 minute ago, mC HULL said: been there mate most are notched in the middle central heating pipes aswell last one i did i had up to run wire for a shower but i put the floorboard the wrong way round but the pipe bent off half way so one end had nail at sides the other in the middle so when i tapped it down the nail went threw lol To misquote Shakespeare’s Shylock; “ If you prick me, do I not bleed ?”. In other words, none of us are perfect….. Your lesson for today, young master ! Cheers. 1 Quote Link to post Share on other sites
paulus 26 Posted December 9, 2023 Author Report Share Posted December 9, 2023 10 hours ago, chartpolski said: To misquote Shakespeare’s Shylock; “ If you prick me, do I not bleed ?”. In other words, none of us are perfect….. Your lesson for today, young master ! Cheers. A slight change to the subject, But you would not believe the amount of motorbikes i have had to rewire because someone has ran the loom over the frame under the seat. The seat just wears through the wires with the weight of the rider on it. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.