robwelsh 354 Posted January 23, 2012 Report Share Posted January 23, 2012 wasnt happy , chrono'd it wasnt constistant atall the highest ftlbs was 10.78ft lbs with croman magnums 10 grains or so...dread to think what it is with lighter pellets.. done a tissue test on it an to find the seal is f****d..blowing back like a bitch..lovely jubbly some new O rings have been ordered...i thought it was accurate...and the few off shots put it down to me, or dodgy pellets,some readings were 10.2 some were 10.36.and some were 10.6 and so on, would this affect the accuracy alot?or was the poor shots down to pellets/me ...how could of i have damaged the O ring? i have had a pellet that got stuck etc before and had to fettle about with it..would it be down to this? to stop it from happening again, atb rob Quote Link to post
stealthy1 3,964 Posted January 23, 2012 Report Share Posted January 23, 2012 If the seals are blown, then you'll get eregular shots and power fluctuation, see if it settles down witht the replacement seals. Quote Link to post
Rake aboot 4,936 Posted January 23, 2012 Report Share Posted January 23, 2012 Seals just go sometimes, Make sure you lubricate the new ring SPARINGLY and fit it properly. Daystates can be fine tuned 3/4 ft lb here or there quite easily, google is your friend, Worth doing if you are replacing the rings anyway. ATB Quote Link to post
robwelsh 354 Posted January 24, 2012 Author Report Share Posted January 24, 2012 Seals just go sometimes, Make sure you lubricate the new ring SPARINGLY and fit it properly. Daystates can be fine tuned 3/4 ft lb here or there quite easily, google is your friend, Worth doing if you are replacing the rings anyway. ATB its the probe rings , i dont know what you mean by Daystates can be fine tuned 3/4 ft lb here or there quite easily, google is your friend, Worth doing if you are replacing the rings anyway. im new to pcps aint got the foggiest mate any info will be taken in... Quote Link to post
robwelsh 354 Posted January 24, 2012 Author Report Share Posted January 24, 2012 iv download a pdf from daystate club, how to polish the hammer and re adjust power levels, but dont really want to attempt it...if thats what you ment by 3/4ft lbs tune Quote Link to post
gurtwurz 793 Posted January 24, 2012 Report Share Posted January 24, 2012 If youre not happy doing the work yourself rob, then maybe take it to a gun shop and let them have a look, at least the work should be guaranteed then mate. Cheers, wurz Quote Link to post
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.