Jump to content

Bad paint job on 2nd hand Rifle


Recommended Posts

Right here goes this is my hw77 bought recently off a tinternet site, Few pics below to show the paint falling off her, :no: I recently posted a topic about dipping rifles but turned out to be far to expensive, :( So im thinking of stripping the action to bare metal and re blueing or powder coating, Has anyone on here striped and re blued a rifle, what was the end result like and how difficult was it to do? Any advice welcomed. :hmm:

 

 

 

http://i229.photobucket.com/albums/ee21/dai1983/bad%20paint/hw77kbadpaint006.jpg

http://i229.photobucket.com/albums/ee21/dai1983/bad%20paint/hw77kbadpaint005.jpg

http://i229.photobucket.com/albums/ee21/dai1983/bad%20paint/hw77kbadpaint004.jpg

http://i229.photobucket.com/albums/ee21/dai1983/bad%20paint/hw77kbadpaint003.jpg

http://i229.photobucket.com/albums/ee21/dai1983/bad%20paint/hw77kbadpaint002.jpg

http://i229.photobucket.com/albums/ee21/dai1983/bad%20paint/hw77kbadpaint001.jpg

Link to post

Really nice refurb mate, Couple of quick questions tho, do you have to very carefull not to get any excess paint into the chamber and barrel, also how come you went for spraying rather than re blueing?

 

 

hi Dia

Q1 Answer:

yes you do buddy,just put some paper towel down each end :thumbs:

 

Q2 Answer:

i went for a spray finish,to try and get as near to the coating that was on there before :thumbs:

re-bluing wasn't an option,as the scratching on the metal was too bad! :thumbs:

 

hope this helps

 

regards

 

Davy

Link to post

Well Ive gone nuts, :D took her out to the garage earlier and stripped the paint metalwork came up a treat, Think i'l degrease and start the blueing tomorrow :thumbs: pics below,

 

 

 

http://i229.photobucket.com/albums/ee21/dai1983/bad%20paint/hw77kblueexp002.jpg

http://i229.photobucket.com/albums/ee21/dai1983/bad%20paint/hw77kblueexp005.jpg

http://i229.photobucket.com/albums/ee21/dai1983/bad%20paint/hw77kblueexp003.jpg

Link to post

Don't believe all the doom and gloom merchants. Chemical bluing is very much a case of proper preparation prevents piss poor paintwork (ok, I know, but bluing doesn't rhyme ok!)

 

Work up through sandpaper grits, until you have a good finish with 3200 grit wet and dry wetted. This should give you a mirror finish. Make sure you thoroughly degrease before applying the chemicals, and apply them according to the instructions.

 

It's not difficult, it just takes some attention to detail to get it right!

Link to post

hi Dia

i used this kit on a HW35K and it turned out OK

 

http://cgi.ebay.co.uk/Birchwood-Casey-Perma-Blue-Liquid-Blueing-Kit-Rifle-Gun-/160316144132?pt=UK_SportingGoods_Hunting_ShootingSports_ET&hash=item2553963a04#ht_1863wt_825

 

but make sure you follow the instructions!

you can use a fine 0000 wire wool to get a good shine and some brasso! :thumbs:

 

ye your right about worring in doing it,as i was.

but its pretty simple if you follow the destructions :thumbs:

 

good luck buddy

 

and let us know how you get on

 

PS.have a look here!

 

http://www.youtube.com/watch?v=TBW2Odrz_vc

 

http://www.youtube.com/watch?v=31SEn4-5PCQ&feature=relmfu

 

regards

 

Davy

Link to post

Ok i rang my local gunshop yesterday and they said they can send it off for a proper bluing and throw in a service for £120,

 

I think im gonna go for this as i need a service and need to test the power, as it second hand an not sure if the previous owner has tampered with it.

 

Plus it will come back like a brand new rifle and will look nice with its bigger brother my HW97kt in my gun Cabinet im gonna build.

Link to post

Sounds like a bargain to me, you'll end up with a beautiful rifle, something to be proud of! Might be worth contacting venom (there's a link on Zini's posts) or one of the other specialist tuners. They might be able to blue/service and tune, adding a huge amount to the value (and shootability) of the rifle. Depends how deep your pockets are. I know venom are very reasonable pricewise though!

Link to post

Ok took rifle into gunsmiths this morning, The guy took a look and said id done a cracking job on the prep work and said to send away you'd be wasting your money, so he gave me a bottle of gun blue and i had a go, starting new topic with pics on how this went, thanks for all the interest and replies tho lads.

Link to post

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...