R10

[pipa 299]

had my R10 shroud shortend the other week, now when i go to zero it it seems to shoot about 5?6" to the left everytime, surley this aint normal? my mate seems to think the end silencer adapter is,nt centered properly?? but i cant see any signs of pellet wear on the inside of the shroud or the silencer??

[Buster321c 1,010]

Ide take it straight back to whoever did it ......................

[pipa 299]

its going back when it opens!

[zini 1,939]

Hi Pipa,

 

If you have had your shroud shortened your barrel will be fine and not touched if you are using a silencer adaptor as this means you are using a mark 2 r10 which is correct.

 

If your barrel is threaded them you are using a mark 1 r10, mark 2’s are not screw cut, the shroud is.

 

I would have a closer look at the silencer and adaptor first buddy.

 

Si

[pipa 299]

hi zini, its just the shroud thats been shortend, then the old silencer thread from the cut off waste shroud put back on, the barrel aint been touched and sits about 5mm back from the end of the shroud, ive tried looking down the into the barrel with the silencer off to see if its out of line but i cant realy tell? ill take it back in for them to have a look at!