hw90k problem

[rabbit.slayer.no.1 3]

ok uys i stuck the site finder on her the other day and she was shooting spot on i mean 5 shots in a 2p size grouping , put her away safe in the cupbourd and never went in there till today . now shes hitting all over , 5 shots with in 6inch grouping any advise on why this is? or how to sort it?

[Phantom 631]

put her away safe in the cupbourd and never went in there till today .

 

Sounds like that your problem! How long was it between shooting her?

Springers like to be held a certain way and after not shooting her for a while, your likely to need a bit more practise

 

I know if I shoot my springer regularly, my shots are consistant, put her away for a couple of weeks and I need a fair bit of time on the paper to bring myself up to speed again

 

Phantom

[rabbit.slayer.no.1 3]

put her away safe in the cupbourd and never went in there till today .

 

Sounds like that your problem! How long was it between shooting her?

Springers like to be held a certain way and after not shooting her for a while, your likely to need a bit more practise

 

I know if I shoot my springer regularly, my shots are consistant, put her away for a couple of weeks and I need a fair bit of time on the paper to bring myself up to speed again

 

Phantom

she was only away for two days . so i cant under stand it. i mate says i need to keep her lieing down and not have her stud up agenst the wall, will this make a diffrence?

[garfield 23]

that makes no difference mate its probably slipped and taken a knock you will have to check the scope again or your gasram may need a service/fill

[Phantom 631]

mate says i need to keep her lieing down and not have her stud up agenst the wall, will this make a diffrence?

 

Nope, most people have their guns in an upright position. Look at the position of gun safes, gun display cabinets etc....

 

Try to re-zero, then stand it on its end fir a couple of days again. If it all goes to cock again, I would say the scope is more likely to buggered than the gun, but it could be that it may need a refil as Garf said.

 

Good luck and let us know how you get on wont you?

 

Phantom

[SEAN3513 7]

do you have a moderator ????

 

if so....check it hasn't come loose......the pellets may be clipping it on exit.....or simply remove it and see if accuracy improves.

 

often an overlooked problem

 

cheers

 

sean

[rabbit.slayer.no.1 3]

ive just took the silincer off to check the baffles to see if its hitting and its not, i think i read some where that with a spring/gasram, its best to hav a one piece mount for the scope , well mine has a two piece. so im going see if i can get a one piece this week . i will let you all know how i get on.