flinty 19 Posted October 10, 2009 Report Share Posted October 10, 2009 hi anybody got a step by step on how to rewire/take apart a lightforce striker????? Quote Link to post Share on other sites
maty j 6 Posted October 10, 2009 Report Share Posted October 10, 2009 hi anybody got a step by step on how to rewire/take apart a lightforce striker????? Press the 2 red bits In and Pull the red bit out the handle and just rewire it. think you need to drill the rivets out too. They seem pritty simple enough but If your asking that question I'm guessing you havn't done much soldering ect before so youre joints will be poor leading to more problems. Quote Link to post Share on other sites
JohnGalway 1,043 Posted October 10, 2009 Report Share Posted October 10, 2009 Soldering isn't hard to do. Before you solder any lamp wires, practice on waste wire and get your technique right. Quote Link to post Share on other sites
flinty 19 Posted October 10, 2009 Author Report Share Posted October 10, 2009 i ment the head were the bulb is Quote Link to post Share on other sites
maty j 6 Posted October 10, 2009 Report Share Posted October 10, 2009 You'll still need to solder. Think you have to drill out the rivets to get into the bulb holder part. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.