charlie nelly1 142 Posted July 14, 2012 Report Share Posted July 14, 2012 Hello everyone, I am after some help and hope my question makes sence! I have a weihrauch hw77 and i have attached the scope onto the rifle however no matter how tight i tighten the allen key holes one the scope it still moves up and down the runners on top of the rifle when i shoot, so i am after some advice on what i may be doing wrong and what i can do to stop it, cheers and i hope you all understand what i mean charlie Quote Link to post
Froudy 40 Posted July 14, 2012 Report Share Posted July 14, 2012 My hw 95 use to do that, take the scope off and have a look underneath on mine there is a hole and if you look in the mount there is a pin that pushes through and then put that in the hole and that will stop it moving if that makes sense hope it helps ATB Froudy Quote Link to post
BenjaminCadd 109 Posted July 14, 2012 Report Share Posted July 14, 2012 Yeah, i know its the same with the tx200 there should be 3 holes drilled countersunk between the dovetails / rails that the mount stop pin can sit in or they do say a one peice mount helps. Quote Link to post
AR177 588 Posted July 14, 2012 Report Share Posted July 14, 2012 Hawke mounts have a grub screw in the one of the mounts which you can screw down onto the rail, scope needs to be out of the mounts to do it ATB Adam Quote Link to post
Skot Ruthless Teale 1,701 Posted July 15, 2012 Report Share Posted July 15, 2012 the recoil screw is a good idea, but even without one your mounts shouldnt be sliding around.. are they damaged? where they are supposed to grip the rails.. i had some cheap mounts that bent over so they wouldnt go on at all. if you know what i mean? Quote Link to post
davyt63 1,840 Posted July 15, 2012 Report Share Posted July 15, 2012 hi buddy you may have the wrong size mounts 15mm instead of 9.5mm / 11.5mm ? to fit the dove tail rail/ grooves. Quote Link to post
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.