Jump to content
Sign in to follow this  
bobcullen79

Variable 170 Rewire Instructional.

Recommended Posts

Right Maplins shopping list.

1 kettle connection male, 1 female.

20mm fuse holder + 20mm 10amp Glass fuses

2mtr black 2 core flex post-45598-0-70196800-1450014579.jpg

Trim the flex as shown. post-45598-0-72252100-1450014624.jpg

 

  • Like 1

Share this post


Link to post
Share on other sites

Add the fuse and male plug, make sure you wire the brown up to the live pin which should be marked inside the plug post-45598-0-09219200-1450014863.jpg

Tape it up leaving a veiwing window so you can see if the fuse blows. post-45598-0-06755200-1450014924.jpg

Share this post


Link to post
Share on other sites

Next, open the handle up and remove the white wedges to remove the old wires. After testing the left terminal was the live, this is where you brown will go... post-45598-0-88514700-1450015158.jpgpost-45598-0-88350000-1450015192.jpg Drill your end cap to fit the new flex snug.

Share this post


Link to post
Share on other sites

post-45598-0-99088900-1450015341.jpg Slide it on your flex and add a cable tie about 25mm after your stripped back wires. Re attache new flex post-45598-0-20985800-1450015476.jpg and reassemble. That`s the hardest bit done.

Share this post


Link to post
Share on other sites

Now for the female connection - the easy bit. Clip off the old cigar connection. The wire with the white writing on, is your live. Wire it up to the live in the female kettle connection. post-45598-0-02659600-1450015825.jpg post-45598-0-75458300-1450015857.jpg

Share this post


Link to post
Share on other sites

Good write up there Bob get this pinned so it will be easy to find for the (future how do I rewire my lamp) :thumbs:

Share this post


Link to post
Share on other sites

Well done Bob wish I'd read this before I destroyed my variable blitz.

 

Do you bother with the wiring behind the bulb holder Bob? Where the dodgy soldering is?

Share this post


Link to post
Share on other sites

I didnt mate, the brightness buttons seemed to be molded into the handle as a sealed unit on the new ones and any other connections I saw looked fine and with no chance of stressing them, so I didnt bother. If a fix comes up I`ll post it on here.

Whilst we are on about fix`s.

My techi mate reckons its fine to hardwire the lamp to the battery plug, no fuse needed.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
Sign in to follow this  

  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...