RemyBolt 420 Posted March 6, 2014 Report Share Posted March 6, 2014 Hello everyone. I know it's pathetic, and a kids toy, but I love my little Crossman Rat Catcher. The thing I hate is that the scope is easily knocked and put off straight. I can get as much as a 3mm knock of the brackets at the front, and an additional 3mm of knock at the back bracket. Meaning my scope is lined off by a good few degrees. Shots at a short range are not too bad, but slightly longer shots can go well off centre! Anyone found a way to remedy this? I've looked at getting the steel top section, because that's got the rail grooves already in place. But I want to know if there are other options available? Any help would be hugely appreciated. Thank you all in advance. Quote Link to post
barrywhite 282 Posted March 7, 2014 Report Share Posted March 7, 2014 i made a little bit of scope rail out of aluminum and attached it where the rear sight goes and used the two scope mounts at the front .this is a little better . Quote Link to post
barnslyben 74 Posted March 7, 2014 Report Share Posted March 7, 2014 Buy the steel breech with scope rail on loads better gmac sell them atb bb Quote Link to post
barrywhite 282 Posted March 7, 2014 Report Share Posted March 7, 2014 Buy the steel breech with scope rail on loads better gmac sell them atb bb at a price Quote Link to post
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.