new scope wont zero

[bigoy19706 276]

hi all i have just fited a tasco 6 24x50 scope to my gun and triyed zeroing it at 15 yards it was shooting about 1 ft to the right the prob is i have screwed the scope all the way to the left and it is still shooting about 10-15cm right from the middle of my target can any one tell me what it might be thanks

[davyt63 1,845]

hi buddy

would help if you told us what air rifle it is? PCP, Spring, CO2, Gas ram,

 

sounds like it needs centering?

 

Davy

[bigoy19706 276]

hi it a bam b20 springer it only a crapy gun but it was ok with the old scope i only got the new scope because the one that where on it was very taty what do you meen by centering thanks

[davyt63 1,845]

hi it a bam b20 springer it only a crapy gun but it was ok with the old scope i only got the new scope because the one that where on it was very taty what do you meen by centering thanks

 

hi

save your self a lot of time and hassle and put the other one back on

 

on a series note,what I mean is if your windage has gone full turns and wont turn no more,turn it back the opposite way and count the full turns,if this is decided by 12 turns, then turn back to 6 and leave do the same with the elevation.

get a piece of A4 paper set it at 10yds and take a shot at the centre, take another shot then move accordingly windage/elevation,one you got it bang on,then move out to 15yds and so on till you reach your desired zero?

 

hope this helps

 

regards

 

Davy

[Pink or stink 162]

Try turning the mounts 180% if the other suggestions fail. (Screws other side).