re parallax

[villaman 9,983]

Hi how do you re parallax a none AO scope say from 15 -50 yards please

Edited August 7, 2011 by villaman

[mikeyblue 28]

Hi,

 

If you look on the very front of the front lens bell, there should be a ring. It may have writing on it like the scope make and model. Try and unscrew this. If you can not do it by hand its likely it is glued in place. If this is the case get some heat on it eg hair-dryer. Once heated try again using a towel wrapped around it.

 

Once this ring is off it should expose the adjustment ring. Simply set a target out at required distance eg 30yds, turn the mag to highest setting, and turn the adjustment ring untill the target snaps into focus. To turn the ring you may need a tool such as a knife to locate into two notches making it easier to turn.

 

Hope this helps!

 

Mikey.