HW100 power DOWN

[Rich91 1]

Anybody got ideas how to take it down to around 11-11.5? I cannot wind the allen bolt down under the back plate cos its bolted.

 

Would re-arranging the disc springs in the regulator make any difference or tightening the bolt which the disc springs sit under make a difference?

 

Thanks,

 

Rich.

Edited June 17, 2011 by Rich91

[Marksman 934]

what do you mean it's bolted???

 

if you mean the 2 small allen bolts, just unscrew them and remove the cap to reveal the allen bolt then adjust as necessary

To adjust the regulator properly you'd need a gauge fitted so you can measure the residual pressure

 

Darryl

[leeroy 29]

Anybody got ideas how to take it down to around 11-11.5? I cannot wind the allen bolt down under the back plate cos its bolted.

 

Would re-arranging the disc springs in the regulator make any difference or tightening the bolt which the disc springs sit under make a difference?

 

Thanks,

 

Rich.

If you go on one of the HW forums there is a section on there with pictures shows you how to do it (sorry cant rember which one). When you get the back plate off hhe power ajuster is there but there is a locking grub screw you have to remove before you can turn it down. Trigger off ect.