Pacific DL266

[roughshooter1 1]

I bought a couple of these old presses and have made a good working one up but would like to bring the other one into action. Has anybody got a gauge die conversation knocking around in the cupboard or an old 266 that they want to sell. Condition immaterial as long as the Dies are on it. Would also consider the DL155 as parts are pretty interchangeable 
Fair price paid
Regards
Graham

[Sausagedog 7,381]

Good luck with that. At one time I could of helped.

Good presses.

Croxton country store had an old press a few years ago. It was blue! May of been a Pacific.

01630 620226.

[roughshooter1 1]

I know - it is like looking for a needle in a haystack.....

the sad part is that there must be loads gathering dust in sheds at the bottom of the garden......

[Meece 1,957]

On 29/08/2019 at 16:01, roughshooter1 said:

I know - it is like looking for a needle in a haystack.....

the sad part is that there must be loads gathering dust in sheds at the bottom of the garden......

You might be lucky but I doubt that there's  loads gathering dust in sheds at the bottom of the garden.  I've reloaded for many years .  It used to be either Lyman, lee, Bowman and Mec.  There were a few exotic makes like Spolar but if you were reloading then it was most often for financial reasons not spending out a small fortune on a reloader.

Edited August 31, 2019 by Meece

[Snarepeg 28]

Graham. 

Have 12 bore parts from a Bair, taken over by Pacific or hornaday ?and am sure interchangeable.

can check as have a 266.

reg. john