Ok step by step well
What you need is
Down pipe reducer
and a bit of tape I
used camo cloth tape
Okay so firstly I
needed to find out the distance that the camera on the iPhone needed to be away
from the scope, After doing that I took the downpipe connector allowed for a
little bit of a overlap roughly 15 to 20 mm on the scope then cut the length I
needed it to be.
Then I took my spare
iPhone case found out where the camera would be in line with the case then
placed it on the end of the downpipe making sure that the camera was directly
in the middle, marked either side of the case on the edge of the tube then cut
out a gap so the phone could have a bit of a seat in the pipe.
then using araldite I
glue it in place.
Then I took the foam tube,
cut it the same length and the down pipe tube, put camo tape around the foam
tube so the super glue had something better to bond to.
Put the pipe up to my
scope, drew round the scope then cut out the shape remembering that I needed to
cut in the depth of the overlay where it will fit on the scope so it was a nice
then simply glued the
foam pipe in to the down pipe using super glue.
Obviously allow time
for both of the glues to set before carrying on to the next stage.
From there I put the
iphone into the case put it on the scope found out the height between the top
of the stock and the down pipe and simply cut the plastic square where the foot
then glued it on.
then should look like
this or similar lol
by the way if any one
wants the plastic feet I can send u one got 5 left pm me and matk on here that
u want one. fcfs
Never done step by
step before so hope it helps