jack 4 Posted May 5, 2011 Report Share Posted May 5, 2011 I was wondering if any of you have trouble with dust or mist on you ir lazer and what you do to prevent this is there a small anoth butler creake or simular that would fit thanks jack Quote Link to post Share on other sites
pestcontrol121 11 Posted May 5, 2011 Report Share Posted May 5, 2011 I was wondering if any of you have trouble with dust or mist on you ir lazer and what you do to prevent this is there a small anoth butler creake or simular that would fit thanks jack Jack there has been a lot of posts about this, the best way i found was to put a 2" to 3" tube over the front of the laser in bad weather conditions, always make sure you clean the lens after use as these marks can be very hard to remove if left. Quote Link to post Share on other sites
jack 4 Posted May 6, 2011 Author Report Share Posted May 6, 2011 Thanks what is best to clean it with Quote Link to post Share on other sites
markha 99 Posted May 6, 2011 Report Share Posted May 6, 2011 micro-fibre cloth Quote Link to post Share on other sites
DERBOY 18 Posted May 7, 2011 Report Share Posted May 7, 2011 i use PURE ACETONE, with cotton bud. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.