slave

The Titan no 9 is for the mk1/2 tx200 the Titan no 10 is the correct spring for the mk3 tx the gun will be way over powered with no 9 titan no 9 part no TS009 outside diameter 21mm inner diameter 14.75mm wire thickness 3.3mm number of coils 27 spring length 280mm titan n0 10 part no TS010 outside diameter 21mm inner diameter 14.8mm wire thickness 3.1mm number of coils 27 spring length 230mm

These might help the first page won't upload as the file is over 500kb x1AASidelever SE 90 Page 2.pdfOLD.SPRING.SIDELEVER.pdf All the Aa side levers use the same action.

Dave Hall is in the Sheffield area he will tune the gun for not much more than 60. contact him directly on: 07411429307 or visit his forum: www.airgunshootersuk.com

The spring has been replaced with a sqare section spring these are not ideal how much preload did the spring have? as it may be to short best to get a replacment. The metal filings could be from the washers the preload washers air arms use are hardened steel lesser quality washers can be chewed up leaving metal filings. Check the condition of the piston seal put the piston in the comp tube put your finger over the transfer port push down on the piston. Check the condition of the breech seals in the comp tube. Also check the lockup of the comp tube make sure there is no play when the gun i

Has the gun got a shroud or silencer? Combros don't like muzzle blast i tried one on a Hw98 and it would only read 1 out 5 shots.

Hi Daz how many lumens was the model you brought?

Parcelforce will only cover you for £100 compensation if your gun goes missing or has "an accident" so posting is a risk.

This might be the case but the anger should be steered towards the mangement not the consumer.

It was probably this tw@t who delivered it.

These might have one http://www.predatorairgunspares.com/career-707sumatra.html

I also have a WTC with broken crosshairs it was second hand so i have no receipt

Try Falcon Accuracy plus .22 5.52 13.43 grains these are made by JSB. http://www.airgunbuyer.com/details.asp?cat=Pellets&SubCat=Pellets&Product=2848

have at look at this http://www.thehuntinglife.com/forums/topic/282731-birmingham-made-22-bsa-supersport-tuned-and-reblued-mint/

Collin Malloy is very good not sure how much but he is very reasonable a couple of members on here have had guns reblued by Collin. You will need to strip out the internals and just send the parts that need rebluing also avoid royal mail this courier has been recomended for gun parts. https://www.myhermes.co.uk/ Collin Malloy contact details 07565582549